Our CrystaLux LED Headlight & Fog Light Bulbs use the latest technologies available in an automotive LED bulb. Our bulbs will be a huge upgrade over your stock headlight bulbs. Available in either our CrystaLux XHP Series or G11 series. Read on and we'll help you determine which product you need.
Our CrystaLux XHP Series Bulbs are offered with one of the best LED technologies available from CREE, the XHP50 LED chip. The dual rolling, non-oil, high temperature durability nylon fans are built into the base of each bulb ensuring a long-lasting lifespan. The bulbs are offered in a 6500 Kelvin temperature rating to achieve that modern look of LED lighting typically offered on high-end luxury cars. These are one of our best selling LED bulbs, which we've been selling for quite a few years now. Actual light output is around 1,048 lux (~20 feet from the source).
Brand new off the line are our G11 Series Bulbs. Using the LatticeBright HGL3 LED Chip these diodes, like the G9 Series, run cooler than the XHP Series. However they still offer a great amount of light on the road. Cooling is achieved with double ball bearing fans. The G11 series however are slightly smaller then the XHP series and are slightly easier to install due to their size. The bulbs are offered in a 6000 Kelvin temperature which is slightly whiter than the G9 Series. Actual light output is around 1,740 lux (~20 feet from the source).
NOTE: These bulbs will not fit vehicles equipped with factory HID lights
Note: The G9 Series are not available in an H13 bulb size and are shown for reference only.
You may experience interference on your radio when running LED or HID products. This is a very common occurrence and an easy solution (if you have some interference on your radio) is to clip on some ferrite cores. These are available on amazon (Link)
Some newer vehicles may require a CANBUS anti-flicker resistor (also called a decoder) as the LEDs use less current then typical halogen lights. This can cause lights to either flicker or go out. The CANBUS Anti-Flicker Resistors place a load on the line and let your computer know your headlights are not out. You may not require the CANBUS anti-flicker resistors. You only need to add/install these if you experience issues with your headlight turning off and/or flickering. There is nothing written in stone that says if you may need these or not. We recommend picking up a pair so that you have them on hand should you run into an issue. It doesn't hurt to install them but they will take up space in the housing.