Description
If you've been looking for an easy to install mount for your ARB Twin Compressor look no further. This system is 100% bolt-on and utilizes the existing bed cleats to mount a compressor securely in your bed. The installation only requires a few hand tools and can be done quickly and easily. The system can be installed on either the driver side or passenger side and on any of the 4 cleats in the bed.
FEATURES
- .125" #304 Stainless Steel
- Powder Coated Black Finish
- Designed & Manufactured in the USA
- Bolt-On Installation
INCLUDES
- KR Off-Road Compressor Brackets
FITMENT
- 2015+ Ford F-150
- 2017+ Ford Super Duty
- Note: If you have a drop in bed liner you may need to trim some of the bed liner around your cleats.
WARRANTY
Lifetime Warranty for the original owner.
(Photos shown may differ slightly based on your installation/options)
OPTIONAL ADD-ONS
POWER EXTENSION HARNESS
Our CrystaLux 25' Power Extension Harness is ideal for anybody installing an ARB Twin Air Compressor inside their vehicle or in the rear of their vehicle. The power harness included with ARB compressors is not long enough to reach the cabin or rear of your truck, which is where our extension harness comes into play.
Utilizing dual 10 gauge power leads for the positive and negative our extension harness ensures minimal voltage drop to the air compressor. The complete extension is 25' long allowing you to easily mount an air compressor anywhere on your vehicle.
One side of the harness has a pre-terminated male plug which plugs into the ARB power harness (which is included with your compressor). The other end is left un-terminated which allows you to route the harness through holes and grommets. A rubber grommet is included with your kit to ensure a clean installation. Simply plug the harness into the ARB power harness, route your wire as you see fit and then slide on the included terminal connector and you're done. Our included terminal connector requires no tools and the power wires just slide right into it.
\
SWITCH HARNESS
Our CrystaLux Switch Harness for ARB Twin Compressors is an ideal harness for your air compressor if you are utilizing a switch. Many customers are mounting a switch right next to the compressor but are forced to run power to the switch separately. Our CrystaLux switch harness plugs directly into the ARB harness on the compressor and provides power to the switch along with a trigger wire. Simply plug the CrystaLux harness into the compressor, connect the 3 leads to the back of your ARB Switch and you can turn the compressor on/off. The switch also lights up as well when activated. Plug & Play!
SWITCH/COUPLER BRACKET
The KR Off-Road Switch/Coupler Bracket can be used in conjunction with some of our KR Off-Road Compressor Mounting Brackets (such as 40-2000 & 40-3000). This bracket mounts to the compressor bracket giving you a place to install your compressor switch & air coupler. You'll still require the following hoses/fittings to complete your kit:
- ARB Air Hose Coupler (JIC-04 37 Degree Flare Fitting)
- ARB Elbow JIC-04(M) JIC-04(F) 2pk
- ARB 90 Deg Elbow JIC4 Male 1/4in NPT Male 2PK
- ARB Hose Reinforced JIC-04 0.5M
