Got Wires? Well you're going to need a way to pass them through the rear-end of your housing without letting moisture in. Here's your answer!
Easy: to use! Just bore out a 3/4" hole in the back or bottom of your headlight housing to seat the flanges of the seal into, then feed your wiring through the nipples on the seal.
Silicone: Each seal is made of a pliable yet durable silicone rubber that wont crack or harden over time. Made to last the life of your headlights!
Four Holes: Each seal has four holes in it, you can easily run four wires, or stretch to fit two through each hole.
Note: Holes may still be sealed and will require you to push a toothpick or drill bit through them to break the seal.