Accessories

Got Wires? Well you're going to need a way to pass them through the rear-end of your housing without letting moisture in. Here's your answer! Easy: to use! Just bore out a 3/4" hole in the back or bottom of your headlight housing to seat the flanges...

Got Wires? Well you're going to need a way to pass them through the rear-end of your housing without letting moisture in. Here's your answer! Easy: to use! Just bore out a 1" hole in the back or bottom of your headlight housing to seat the flanges of...

When an LED/HID Headlight Conversion kit is installed in newer car model or cars with a computer controlled unit, often there is an error code showing on the dash board or the LED/HID Headlights keep flickering and will not stay on. This is due to the...

Add some extra length to your existing wires with these extension wires. Perfect for retrofit installations where you need to install a ballast/driver outside of your housing. A great idea whenever you need to splice into the factory wiring without fear...

J-B Weld Ultimate Black Gasket Maker & Sealant is an RTV (Room Temperature Vulcanized) Silicone gasketing material designed for use in mechanical assemblies where maximum petroleum and oil resistance is required. Upon curing, which occurs when the...

It is recommended that you install the ballast/driver on the outside of the headlight cavity on the 2015+ Ford F-150s. Due to the design of the 2015+ F-150 housing, the led ballast will create additional heat within the headlight cavity and possibly...

Seal It Up: Retrofit left the back side of your housings a bit open to the elements? These rubber housing caps may be the perfect solution to re-seal. Sizing: Available in seven different diameters to fit the most common headlight flanges:...